Skip to main content
Skip table of contents

System Backups

Note: To use backups, Store User Codes must be enabled in Dealer Admin. This allows SecureCom to send full programming and user codes back to the panel, eliminating the need to manually reprogram user codes after a system is restored.

When a system is created in Dealer Admin, programming is backed up automatically and once per month afterward. Each panel has a total of three backups in Dealer Admin. One is permanently reserved for initial programming created within 24 hours of the installation. The other two can be overwritten and are used for automatic or manual backups. To access Backups, go to System Information.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.