Key Fobs

In this section, you’ll learn how to add, edit, and delete key fobs from a system.

For complete information, refer to the appropriate installation and programming guides from DMP.com/resources.

Refer to the following information:

Add a Key Fob

To add a key fob to a system, complete the following steps:

1. Log in to Dealer Admin (dealer.securecomwireless.com).

2. Go to Customers and select the System Name.

3. In left menu, go to Programming > Key Fobs.

4. Select + Add Key Fob.

5. In Key Fob Number, enter a number depending on your system type. Refer to the table following this section.

6. In Number of Buttons, select 1, 2, or 4. Default is 4.

7. In Username, select an existing user.

8. In Serial Number, enter the 8-digit key fob serial number.
   The valid range is 05000000-05999999.

9. If the key fob should be supervised, select 60 min or 240 min for the Supervision Time. For applications where the key fob may be taken off site, supervision time should be None. The default is None.

10. Program each button (Top, Left, Right, Bottom) as needed, including the Action, Press Time, Areas, Output (panic), and Output Action (panic).

11. Select the (More) icon, then select Send Key Fobs.

Enable Wireless Encryption and Panic Supervision

Enable Wireless Encryption for encrypted key fob models. Both allows both encrypted and unencrypted key fob models to operate on the system. All requires that all key fobs programmed must be encrypted models.

Enable Panic Supervision if you want fobs to have a 30-day supervision that reports transmitter lost or low battery conditions without requiring a Supervision Time for the key fob.

1. Log in to Dealer Admin (dealer.securecomwireless.com).

2. Go to Customers and select the System Name.

3. In left menu, go to Programming > System Options.

4. To enable wireless encryption, go to 1100 Wireless Encryption, then select Both or All.

5. To enable panic supervision, toggle Panic Supervision ON.

6. Select the (More) icon, then select Send System Options.

Edit a Key Fob

To edit a key fob, complete the following steps:

1. Log in to Dealer Admin (dealer.securecomwireless.com).

2. Go to Customers and select the System Name.

3. In left menu, go to Programming > Key Fobs.

4. Select a key fob.

5. Edit key fob programming as needed.

6. Select the (More) icon, then select Send Key Fobs.

Delete a Key Fob

To delete a key fob from the system, complete the following steps:

1. Log in to Dealer Admin (dealer.securecomwireless.com).

2. Go to Customers and select the System Name.

3. In left menu, go to Programming > Key Fobs.

4. Find the key fob that you want to delete.

5. Select the (More) icon, then select Remove.

6. A dialog pops up to confirm your decision. To delete the key fob, select Remove.