Remote Options

Complete the following steps to program Remote Options for the panel:

The Remote Key is used to authenticate remote communication to the panel. All panels are shipped from the factory with the key preset as blank. This can be an optional or required setting.
Leave Remote Disarm toggled ON to allow the system to be disarmed remotely. This option is toggled ON by default.
Enter the APN. The default is SECURECOM400.
Enter the App Key used to enable EASYconnect.
Enter the Network Programming Port. This option is used to identify the port used to communicate messages to the panel. The default is 2001.
Program Integrator options below or select the (More) icon, then select Send Remote Options.

Integrator

Select Integrator to program Integrator options.
In Integrator Connection, select None or Network.
If you selected Network, program the options below:
Enter the Integrator Incoming TCP Port. The option identifies the port used to communicate messages to and from the integrator software. This port cannot be the same port as programmed in Network Programming Port. The default is 08011.
Enter the Integrator IP Address where the panel sends network messages. The Integrator IP Address should be unique and cannot be duplicated on the network. The default is 0.0.0.0.
Enter the Integrator Outbound TCP Port for outbound connection. The default is 08001.
In Integrator Backup Connection, select None or Network.
If you selected Network, enter the Integrator Backup IP Address and the Integrator Backup TCP Port.
Leave any of the following options toggled ON to send reports to the integrator. The integrator reports are toggled ON by default.
- Integrator Arm/Disarm Reports
- Integrator Zone Reports
- Integrator User Command Reports
- Integrator Door Reports
- Integrator Supervisory Reports
Enter an Integrator Passphrase to encrypt communication with the integrator.
Toggle Integrator Video Reports ON to send video reports to the integrator.
Select Send All Changes at the top of the screen.